![]() ![]() When lubricating, make sure to use a 100% silicone non-aerosol treadmill lubricant and apply about 1 ounce. The frequency of the lubrication varies depending on the model. It is important to keep a proper lubrication schedule for your treadmill. The motor control board will turn off automatically when the motor is pulling too much current triggering the safety shut down. If the running belt moves for several minutes and then throws the “E1” error code, this probably means the running belt needs lubrication. ![]() The “E1” error code basically means the console is not getting any reading from the speed sensor or the reed switch. This will help determine whether your issue lies with the motor or the center console. When your treadmill triggers this error code, it is important to know when the problem happened and what you are doing when the error is triggered. If your treadmill is not turning on, please watch the following video. This means the error can be triggered by many different reasons. You must stop the treadmill immediately after seeing this error as it can cost you long time damage.Īccording to, an “E1” error code in a treadmill is a very broad code. If the treadmill stops soon after starting, then either the speed sensor needs replacement or calibration.In this case, you might have to replace the motor and motor control board. This means that the belt can no longer absorb lubrication because of the pores on the underside of the belt. Press the Speed + or - button until ENG2 appears in the display. will beep and ENG0 appears in the display. approximately 5 seconds to enter the Engineering Mode. Press and hold the elevation + and speed - buttons for. If after lubricating, you experience the error again, then the belt may have glazed. SOLUTION: Auto-calibrate the treadmill: console.It is very important to maintain since the motor will pull too much current and heat up and then will suffer a safety shut down. We have removed the cover to be sure that it isnt. I have a Horizon treadmill and have lubed the belt, cleaned everything and tensioned the belt but the running belt is slightly buckled in the center. If this error occurs after the belt moves for a long time, then the belt requires lubrication. If the console lights up, but the T101 won’t start, then you need to inspect the motor controller board. Tried online troubleshooting and nothing worked.E1 error code simply conveys that the console isn’t getting a response from the Speed Sensor. Hence, we must know the point (what the person was doing on the machine) when this code occurs. Resume Exercise By Fixing Horizon T101 Treadmill E1 Errorįirst of all, I would like to tell that E1 is a very wide error code.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |